Skip to content
Social WiFi Academy

Zyxel Nebula

Compatibility

Social WiFi has been tested and is proven to work on the following configurations:

Zyxel Nebula Control Center

  • Access point firmware: V6.10(ABDF.8)

Access the administration panel

This guide assumes that the device is already connected with Zyxel Nebula Control Center.

Wireless network configuration

Go to Access point → SSID settings.

image_810270.png

Make sure that Simple mode is disabled. Set the Name for the WiFi network (e.g. “Social WiFi”), make sure that Enabled and Guest Network are switched on.

image_869907.png

WLAN security

When in the Access point → SSID settings, next to WLAN security, click on Edit.

image_849739.png

In the Network access section, use the following settings:

Security optionsOpen
Sign-in methodSign-on with: My RADIUS server
RADIUS server - Host35.205.62.147
RADIUS server – Port31812
RADIUS server – SecretRADIUS Secret is available in Access Points tab of the Social WiFi dashboard
RADIUS accountingRADIUS accounting enabled (optional, but recommended)
RADIUS accounting servers – Host35.205.62.147
RADIUS accounting servers – Port31813
RADIUS accounting servers – SecretRADIUS Secret is available in Access Points tab of the Social WiFi dashboard

image_612819.png

In the Captive portal advance setting section, use the following settings:

Walled gardenSwitched on
Walled garden ranges*copy below*
Simultaneous login limitUnlimited
Strict PolicyBlock all access until sign-on
Reauth timeFollow site-wide settings (you can set preferred forced guest logout time here)
*.socialwifi.com
sw-login.com
*.facebook.com
*.fbcdn.net
*.twitter.com
*.twimg.com
*.linkedin.com
*.licdn.com
*.x.com
*.googleapis.com
apis.google.com
www.googletagmanager.com
www.googleadservices.com
googleads.g.doubleclick.net

image_571312.png

Leave the Traffic options and Advanced settings sections as they are.

Click the green Back button at the bottom of the page to go back to the SSID settings screen.

Captive portal customization

When in the Access point → SSID settings, next to Captive portal customization, click on Edit.

image_729780.png

In the External captive portal URL section, use the following settings:

Use URLhttps://login.socialwifi.com

In the Captive portal behavior section, use the following settings:

After the captive portal page where the user should go?To promotion URL: https://login.socialwifi.com/redirect/

image_301696.png

Click the green Back button at the bottom of the page to go back to the SSID settings screen.

When in the Access point → SSID settings, click the green Save button at the bottom of the page.

image_357449.png

Add the access points to Social WiFi panel

The setup of the controller is now finished. The last step is to add all access points to the Social WiFi platform.

Go to Access point → Access points in the menu on the left. Find the MAC address column. You will need those MAC addresses in the next step.

image_250589.png

image_578878.png

Now, switch to Social WiFi Panel, go to Access Points tab, click the Add button and paste the MAC addresses of all of your access points controlled by the Zyxel Nebula. Click Create.

image_174341.png

Test the solution

Connect with the WiFi network. You should see a login page. Go through the login process and, once finished, you should have internet access.

You should see first connections and authorizations in the Social WiFi Panel’s statistics section.

Firewall

If you have any Firewall behind your Zyxel Access Point, make sure that these ports are enabled:

  • 443 i 6667 (are used in TCP for Nebula Cloud Management)
  • 123 (used in UDP for Network Time Protocol(NTP)