Device mode
Prerequsites
If the device was shipped with RouterOS v7.17 or later pre-installed, you must ensure that the device mode is set to advanced.
Setting up the device mode
Access the router by following the steps below:
- Start Winbox.
- At the top, set “Select from” to “Neighbours”.
- The router should appear on the list - double-click it.
- Click the blue “Connect” button.
In the terminal window, press CTRL+C.
Copy and paste the below to the terminal:
system device-mode update mode=advanced
Press ENTER.
Unplug the router from power, wait 5-10 seconds and plug the power back again to the router. Wait until it boots back up.
After the router boots back up, you will be reconnected to the device and the device mode will be set correctly.